Pleat On!

January 18, 2017   /   byMainelydad  / Categories :  Feeds




I think the scariest part about making a kilt is that it's just based on 3 measurements that someone else has taken. You have to give up every shred of control and place your faith in someone that you hope is taking the job seriously. That's hard for a control freak like me. I had my son, who has NO sewing experience whatsoever, measure me. Then, unbeknownst to him, I had my very OCD friend David do it. If you've got that kind of friend in your life I highly recommend it, purely for the peace of mind! In the end their measurements were almost identical. David gave me an extra 1/2" of length, and I'm taking it. I'd rather have a little extra length than end up with a plaid miniskirt.


So that's pattern, no muslin, no dry run. Three measurements.




The book I'm using is unapologetically traditional in its methods. Everything is marked with chalk. That might be fine for an experienced kilt maker, but I found myself handling my fabric so much that my marks were quickly wiped away. As a result I misplaced my first pleat! Not a great start. So I resorted to more reliable techniques. I remarked all the pleat spacing with Wonder Clips and triple checked myself. (Any mistake is almost unfixable). Then I popped in a tailor tack at each clip. No more lost chalk marks. I also thread traced the edges of the overlapping fronts (the "aprons" in kilt speak).


You can see a few of the clips in the above picture. This is 5 yards of fabric that's perpetually sliding back and forth on the table.






My kilt will have 22 pleats across the back. The set of three black blocks is centered on the front of the kilt, so it should also be centered on the back. That took a bit of trial and error but I eventually got there. Each pleat is 1" at the hip (the "fell" in kilt speak) and tapers to 7/8" at the waist. The amount of taper is determined by the difference between the hip and waist measurement. Mine is minimal since I have a flat buttock and the waist is measured 2" above a person's natural waist.


I'm sorry I don't have more detailed photos of the pleating process. There's a certain rhythm to the sequence. In short, the next pleat has to be formed and held in place before stitching the pleat one's currently working on. This is all to be accomplished by pinching the pleats with the left hand and stretching the fabric over one's thigh. With the fabric stretched the pleat is hand sewn with small invisible edge stitches. Somehow everything is supposed to end up perfectly straight and aligned. IN MY DREAMS!


I quickly realized that I would have to make a hundred kilts before I could master this technique. Anyone who's followed this blog knows that I'm a baste-o-holic, so I posed a question about basting on "X Marks the Scot". Stand back! This set off a small firestorm between the traditionalists and the more modern kiltmakers. After the dust settled I pretty much ignored all their advice and proceeded to baste all my pleats. In the end it's all about what works, right?


Even with all my basting, sewing the pleats accurately was no small feat. The horizontal red stripe was particularly difficult to keep aligned. There's definitely a knack to it. Maybe on my hundredth pleat I might have it down. Sometimes you just have to say it's "good enough for a first kilt".



So here is the completed back, pleated to the sett, with all the pleats basted into place. A good place to take a break and read up on the next step.


This is a syndicated post. Please visit the original author at The Japanese Pattern Challenge

You may like

Sew Sweetness+Sizzix Maker’s Challenge

I’m very excited to announce my partnership with Sizzix+Free Spirit Fabrics to bring you the Sew Sweetness Maker’s Challenge! The winner will be randomly drawn from all entries received, and the prize is a bundle of Free Spirit fabric, Sizzix Big Shot Plus Machine, and the NEW FALL Sew Sweetness dies to be launched in […]

The post Sew Sweetness+Sizzix Maker’s Challenge appeared first on Sew Sweetness.

read more

Fujifilm X-T2 Review

I have been receiving a lot of of requests for a review on my Fujifilm X-T2. As some…

read more

Cashmerette Springfield top

I’ve had pleasing results from the Cashmerette patterns I’ve used so far, but they have been designed for knits.  The Springfield top was my first foray into a Cashmerette pattern that was designed for wovens. From the Cashmerette website: Make room in your closet for the Springfield Top! This woven shell is ideal for layering under… Continue reading Cashmerette Springfield top

read more

How to sew the waistband and placket // A Matilda dress tutorial

Today i’m going to show you how to sew the waistband and placket of the Matilda dress! I find this part of the dress construction to be the most exciting – it’s when we join the bodice and skirt together and it finally starts to look like a dress! Ready to sew? Lets do it! […]

The post How to sew the waistband and placket // A Matilda dress tutorial appeared first on megan nielsen design diary.

read more
Jan 2016 Accuquilt Sale